HENRY W W CO -- HENRY 430 CLEAR THIN-SPREAD FLOOR TILE ADHESIVE  -- 8040-01-261-4187
<pre>=====================  Product Identification  =====================

Product ID:HENRY 430 CLEAR THIN-SPREAD FLOOR TILE ADHESIVE
MSDS Date:04/01/1997
FSC:8040
NIIN:01-261-4187
Status Code:A
=== Responsible Party ===
Company Name:HENRY W W CO
Box:3001
City:LANCASTER
State:PA
ZIP:17604
Country:US
Info Phone Num:717-396-2328;717-396-2935
Emergency Phone Num:800-255-3924
CAGE:11761
=== Contractor Identification ===
Company Name:HENRY W W CO
Box:3001
City:LANCASTER
State:PA
ZIP:17604
Country:US
Phone:717-396-2328;717-396-2935
CAGE:11761

=============  Composition/Information on Ingredients  =============

Ingred Name:VM & P NAPHTHA (PER MSDS:MAY VARY DEPENDING ON SOLVENT
    SUPPLIER)
CAS:64742-89-8
Fraction by Wt: 2-3%
Other REC Limits:NONE RECOMMENDED
OSHA PEL:300 PPM
OSHA STEL:400 PPM
ACGIH TLV:300 PPM

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE:EYE/SKIN:MAY CAUASE
    DRYING/CRACKING OF SKIN, DEFATTING OF TISSUE, DERMATITS. CONTACT
    W/EYES: IRRIT. INHAL: VM&P NAPHTHA MAY CAUSE IRESP TRACT IRRIT,
    COUGHING, CNS EFFECTS-HEADACHE, DIZZINESS, DR OWSINESS, NAUSEA.
Effects of Overexposure:TARGET ORGANS: UPPER RESP TRACT, SKIN, EYES.
Medical Cond Aggravated by Exposure:ANY CONDITIONS GENERALLY AGGRAVATED
    BY SOLVENTS, INCLUDING PRE-EXISTING UPPER RESP & LUNG DISEASE:
    BRONCHITIS, EMPHYSEMA, ASTHMA, & EXISTING SKIN CONDITIONS.

=======================  First Aid Measures  =======================

First Aid:EYE: IMMED FLUSH W/PLENTY OF WATER FOR @LEAST 15 MINS. REMOVE
    CONTACT LENSES.HOLD EYELIDS OPEN. GET IMMED MED ATTN. SKIN:REMOVE
    CONTAMIN CLOTH/SHOES. WASH THOROUGHLY W/SOAP/WATER. IF IRRIT
    PERSISTS, G ET MED ATTN. INHAL:REMOVE TO FRESH AIR. IF SYMPTOMS
    PERSIST, GET MED ATTN. INGEST:DO NOT INDUCE VOMITING. GET IMMED MED
    ATTN.

=====================  Fire Fighting Measures  =====================

Flash Point Method:SCC
Flash Point:>93.3C, 200.F
Autoignition Temp:Autoignition Temp Text:NP
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, HALON, WATER SPRAY
Fire Fighting Procedures:PROTECT FIRE FIGHTERS FROM TOXIC PRODUCTS OF
    COMBUSTION: WEAR SELF-CONTAINED BREATHING APPARATUS & FULL
    PROTECTIVE GEAR.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS IN A FIRE MAY RUPTURE
    DUE TO PRESSURE BUILD UP. USE WATER TO COOL CONTAINERS TO PREVENT
    THIS.

==================  Accidental Release Measures  ==================

Spill Release Procedures:VENTILATE AREA. CONTAIN SPILL. PREVENT FROM
    ENTERING SEWER LINES OR WATERWAYS. USE ABSORBENT TO ASSIST WITH
    PICK UP OF MATERIAL. SCRAPE UP PRODUCT & PLACE INTO CONTAINER.
    RESIDUAL OF PRODUCT WHILE STI LL WET CAN BE CLEANED UP W/ WARM
    SOAPY WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE IN AREA SUITABLE FOR COMBUSTABLE
    MIXTURES. STORAGE TEMPERATURE IS BELOW 90 F. VAPORS ARE HEAVIER
    THAN AIR. USE PRECAUTIONS THAT ARE COMMON W/ SAFE HANDLING OF
    COMBUSTABLE LIQUIDS.
Other Precautions:WORK SITE ENVIRON:INITIAL POTENTIAL ADVERSE IMPACT ON
    INDOOR AIR QUALITY DURING INSTALLATION PROCESS.NOTIFY MANAGMENT
    NECESSITY TO MAINTAIN ADEQUATE VENTILATION W/OUT CAUSING SPREAD OF
    CONTAMINANTS TO  OTHER PARTS OF BUILDING.PERSONS SENSITIVE TO
    ODORS/CHEMICALS ADVISED TO AVOID WORK AREA DURING PROC ESS.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:WITH ADEQUATE VENTILATION, RESP EQUIP SHOULD NOT
    BE NEEDED. IF NOT, WEAR NIOSH APPROVED RESP EQUIP FOR ORGANIC
    VAPORS.
Ventilation:USE NATURAL CROSS VENTILATION. LOCAL(MECH) PICK UP, AND/OR
    GENERAL AREA (MECH) VENTILATION TO PREVENT ACCUMULATION OF VAPORS.
Protective Gloves:NORMAL USE:COTTON/LOOP-PILE GLOVES.
Supplemental Safety and Health
VENTILATION PATTERNS MUST REMOVE HEAVIER THAN AIR SOLVENT VAPORS FROM
    THE LOWER LEVELS OF WORK SPACES. VENTILATION MUST BE SUFFICIENT TO
    KEEP THE SOLVENT VAPOR CONCENTRATIONS BELOW TLV.

==================  Physical/Chemical Properties  ==================

Boiling Pt:=100.C, 212.F
Melt/Freeze Pt:M.P/F.P Text:NA
Decomp Temp:Decomp Text:NP
Spec Gravity:1
VOC Pounds/Gallon:49
pH:9.2,NON PHOTOCH
Viscosity:NP
Solubility in Water:DISPERSIBLE.
Appearance and Odor:BEIGE CREAMY PASTE, MILD SOLVENT ODOR.
Percent Volatiles by Volume:56-58@200F
Corrosion Rate:NP

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE KNOWN.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE, &
    TOXIC VAPORS AND GASES COMMON TO THERMAL DEGREDATION OF ORGANIC
    COMPOUNDS.

=====================  Ecological Information  =====================

Ecological:CONTAINS SPILLS, PREVENTING THEM FROM ENTERING SEWER LINES
    OR WATERWAYS. DO NOT FLUSH UNUSED CONTENTS OR RESIDUE DOWN DRAINS.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE AND
    FEDERAL REGULATIONS. DO NOT FLUSH UNUSED CONTENTS OR RESIDUE DOWN
    DRAINS. DO NOT REUSE CONTAINER.

=====================  Regulatory Information  =====================

SARA Title III Information:THIS PRODUCT DOES CONTAIN CHEMICALS SUBJECT
    TO THE REPORTING REQUIREMENTS OF SECTION 313 SARA III AND 40 CFR
    372.
Federal Regulatory Information:ALL COMPONENTS ARE ON TSCA INVENTORY.
    IPD PRODUCTS DO NOT CONTAIN ASBESTOS.

 ======================================================================
 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.